BluePill

The BluePill is an inexpensive Arduino style microcontroller board built around the STMicroelectronics ARM Cortex-M3 STM32F103CT6 microcontroller.

The 32-bit microcontroller runs at 72MHz, has 20k of RAM, 128k of flash, and a shitload of GPIO pins. At around $5 each, it's basically superior to all the Arduino options, at a fraction of the price.

VBAT can accept from 3 - 5VDC.

3V3 pins can alternatively be used to power the chip directly.

VBAT is not connected directly to USB P+. Do not power it from one of the pins and from the USB port at the same time.

To flash:

The USB port is basically useless.

- Connect a TTL-Serial adapter connected to UART1 (Pins PA9 & PA10 above, A9 A10 on the silkscreen).

- Set the "boot" jumper (top) to 1 (rightmost position).

- Press the [RESET] button

- Start your upload

The program will execute immediately upon uploading, but not upon reset until you set the "boot" jumper back to 0.

PlatformIO Configuration:

platform: ststm32; board: bluepill_f103c8; framework: arduino

platformio.ini settings using arduino framework and TTL Serial Upload:

[env:bluepill_f103c8] platform = ststm32 board = bluepill_f103c8 framework = arduino upload_protocol = serial upload_port = /dev/ttyUSB0

Analog (0-3.3v) measurement:

The 10 analog Input pins are 12-bit resolution.

Analog inputs: PA0 - PA7, PB0, PB1